Farm & machinery sheds for Dubbo and the Orana.
Open-front machinery sheds, enclosed grain and fertiliser stores, tall hay sheds and equipment workshops. Engineered portal frames built to the wind and soil conditions of the Central West NSW plains, supplied and erected on your block.
Sheds sized to the job, not the catalogue.
A farm shed near Dubbo earns its keep every day, so the worst outcome is a structure that is a metre too short for the header, an eave too low for the telehandler, or a frame that flexes in a westerly off the open plains. We start with what you actually store and move, then design the clear span, the eave height and the door positions around that. Most of our Orana work falls into four formats.
Open-front machinery sheds.
The classic 3, 4 or 5-bay machinery shed with an open or part-open front so the tractor, header, boom spray and trailers reverse straight in. Bay widths of 7m to 9m clear suit most gear, and an eave of 4m to 5m clears a cab and a raised comb front. We brace the rear and end walls so the open front does not turn the shed into a sail when a southerly comes through Wongarbon and Geurie.
Enclosed grain and fertiliser stores.
Bulk storage pushes load against the walls, so these sheds need a heavier portal frame, a sealed and reinforced slab and good ridge ventilation to manage condensation through a Central West winter. A 18m x 12m enclosed store is a common size for an Orana mixed-farming operation holding seed and urea under cover.
Hay sheds.
Hay wants height and airflow. We typically run a 5.5m to 7m eave with an open front and a steep enough roof pitch to shed water fast, so the stack stays dry through a wet spring. Round or square bales, the bracing is designed for the gust loads on a tall open structure on a cleared paddock.
Workshops and lockable equipment sheds.
When the shed doubles as a workshop you want a concrete slab, a personal access door, decent natural light through translucent roof sheets, and a roller door sized for the biggest thing that goes in and out. We can add a lean-to skillion down one side for the ute, the quad and the consumables.
Built for Region A wind and reactive clay.
Dubbo sits on the inland slopes where AS 1170.2 Region A wind loads apply, but a fully cleared paddock toward Narromine or Gilgandra carries a worse terrain category than a sheltered town block, which raises the effective wind speed the frame has to resist. We engineer to the actual site so the footings, the portal spacing and the bracing match your exposure, and the structure earns its engineering certificate.
Much of the black and grey cracking clay around the Macquarie Valley is highly reactive, swelling and shrinking with the seasons. That is why we size the pad footings to the soil class rather than dropping in a standard stump depth: a shed footing that heaves will rack the frame and jam the doors within a couple of seasons. Compare typical figures on our shed cost in Dubbo guide, and check what needs approval on the rural NSW shed permits page before you lock in a size.
A 4-bay machinery shed near Geurie.
A 24m x 9m x 5m open-front 4-bay machinery shed on a cleared block toward Geurie works out around $48,000 to $66,000 supplied and erected in 2026, before slab and power. The slab adds roughly $14,000 to $22,000 depending on thickness and reinforcement for the soil class. Add a roller door and a personal access door to lock one bay and you are near $70,000 to $90,000 all in. We give you a fixed written quote that itemises the frame, the cladding, the doors, the slab and the certification so there are no surprises at handover.
Where we build.
Need a smaller building? See our garages, carports and industrial sheds instead.
Common farm shed questions.
How much does a farm shed cost in Dubbo?
As a 2026 guide for the Dubbo and Orana region: a basic open-front machinery shed (around 12m x 9m x 4m) runs roughly $22,000 to $38,000 supplied and erected; a fully enclosed 18m x 12m x 5m farm shed with a roller door and personal access door sits around $55,000 to $90,000; a large 24m x 15m x 6m hay or grain shed is commonly $95,000 to $160,000. Concrete slab, power, lighting and council certification are extra.
What wind rating do farm sheds in the Dubbo region need?
Most rural blocks around Dubbo, Geurie, Wongarbon and out toward Narromine sit in Region A under AS 1170.2, the standard inland wind region. Exposed ridge-top or fully cleared paddock sites push the terrain category up, which increases the design wind speed the frame must resist. We engineer every shed to the actual site, not a generic kit rating.
Do you build sheds for hay, grain or fertiliser storage?
Yes. Hay sheds want a tall clearance (5.5m to 7m to the eave) and an open front for telehandler access. Grain and fertiliser sheds need a sealed slab, good ventilation and a higher portal frame to take bulk loads against the walls. We design the bracing and footings for the specific load.
Can I get a farm shed approved as exempt development in NSW?
On many rural-zoned blocks in the Dubbo Regional council area a farm shed can be approved as exempt or complying development if it meets the State Environmental Planning Policy size, setback and use limits. Larger sheds, sheds close to a boundary, or commercial-use sheds need a development application. We sort out which path applies before you commit to a size.
Free measure and quote on your block.
We come to the paddock, check the soil and exposure, and give you a fixed written quote.